• 9.3kW pyramid flame tower patio heater
• Modern design
• Stainless steel construction
• Low gas consumption
• Large cylinder enclosure
• Ambient light effect
• Built-in electric ignition
• Adjustable heat settings
• Toughened centre tube

Precautions  Ensure the connection to the gas bottle has been tightly secured with a spanner where necessary.  Leak test all connections after each bottle re-fill  Never check for leaks with a match or open flame  Do not store or use gasoline or other flammable vapours and liquids in the vicinity of this or any other appliance  Any LPG bottle not connected for use shall not be stored in the vicinity of this or any other appliance For your safety – if you smell gas Turn off the gas supply at the bottle. Extinguish all naked flames; do not operate any electrical appliances. Ventilate the area. Check for leaks as detailed in this manual. If odour persists, contact London Cool immediately on 0800 440 444. FOR OUTDOOR USE ONLY The use of this appliance in enclosed areas can be dangerous and is PROHIBITED. Using this product in an enclosed area may cause injury, death or property damage. Read the instructions before using this appliance. This appliance must be installed in accordance with instructions and local regulations. WARNING!  For use outdoors or in amply ventilated areas  An amply ventilated area must have a minimum of 25% of the surface area open  The surface area is the sum of the walls surface Do not use this heater in an explosive atmosphere. Keep the heater away from areas where gasoline or other flammable liquids or vapours are stored. Prior to use, check for damaged parts such as hoses, regulators, pilot or burner. Do not move the heater when in operation. Shut off the valve at the gas cylinder before moving the appliance. Disconnect the LPG bottle before moving the heater. Do not attempt to alter the unit in any manner, e.g. using the heater without the top canopy reflector or radiant screen. The appliance shall not be used in basements or above ground level. It must always be placed on a solid level surface. Always ensure there is ample fresh air ventilation. Never replace or substitute the regulator with any other regulator other than the factory suggested replacement. Do not clean the heaters with cleaners that are combustible or corrosive. Do not paint radiant screen, control panel or top canopy reflector. All leak tests should be done with a soapy solution. NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS. The LPG gas bottle valve and regulator should be turned off when the heater is not in use. Do not use when it is raining, always be careful not to let any liquid splash the glass tube when the heater is working. Keep children away from the heater, always be careful not to knock over the heater which will break the glass tube and may cause injury. The following clearance distances are required for safe operation when using this heater. It is important you keep these distances from combustible materials: minimum clearance to adjacent combustibles: from top: 61cm, from sides: 60cm. Check the heater immediately if any of the following exists: 1. The smell of gas 2. The heater does not reach temperature 3. The burner makes a popping noise during use (a slight popping noise is normal when the burner is extinguished after use) If you smell gas, turn off the valve immediately. If the smell persists, contact London Cool immediately. The propane hose with regulator assembly shall be located out of the pathway where people may trip over it or in areas where the hose will not be subject to accidental damage. Children and adults should be aware of the high surface temperature hazard, and should keep a safe distance away to avoid clothes burning or igniting. Young children should be carefully supervised when they are in the area of the heater. Clothing or other flammable material should not be hung from the heater, or placed on or near the heater. Any guard or other protective device removed for servicing the heater must be replaced prior to operating the heater. Installation and repair should always be carried out by a qualified service person. The heater should be inspected before use and cleaning may be required at least once a year, or as necessary. It is imperative that the control compartment, burner and circulating air passageways of the heater be kept clean. Keep the appliance area clear of combustible materials such as gasoline and other flammable vapours and liquids. Do not obstruct the flow of combustion and ventilation air. Do not obstruct the ventilation holes of the cylinder housing. Keep the ventilation opening of the bottle enclosure free and clear of debris. Note: when changing the bottle, the appliance must be in a amply ventilated area and must be away from any ignition source (candles, cigarettes, other flame producing appliances). Avoid twisting the flexible tubing while using. Never use the appliance near a fire hazard. WARNING! The appliance must ONLY be used for outdoor use. The installation of fixed appliances shall only be carried out by competent persons and be in accordance with the relevant codes of practice. Regularly check the gas hose and if necessary, replace the gas hose. This appliance requires a regulator. Combustible materials are considered to be wood, compressed paper, plant fibres, and plastic, Plexiglas or other materials capable of being ignited or burned. Such materials shall be considered combustible even though flame proofed, fire-retardant treated or plastered. Additional clearance may be required for glass, painted surfaces and other materials which may be damaged by radiant or convection heat. The hose assembly should be properly located out of pathways where people may trip over it. The hose must be protected from contact with hot or sharp surfaces both during use and while in storage. The hose assembly should be visually inspected prior to each use of the heater. If excessive abrasion or wear is evident, or the hose is cut, it must be replaced prior to operating the heater. The replacement hose assembly may be obtained from the manufacturer. DO NOT use any pressure regulator or hose assembly other than those supplied with the appliance or provided by your gas supplier. Replacement pressure regulator and hose assembly must be those specified. Replacement parts may be obtained from the manufacturer or London Cool. The valve outlet must be maintained in good condition. When the bottle is not in use, be sure to cover it with a dust cap. A leak test should be performed with soapy water whenever connecting a new bottle of gas. NEVER use a match to test for leaks. The propane bottle must be turned off whenever the heater is not in use. When the heater is to be stored indoors, the propane bottle and the heater must be disconnected and the bottle stored in accordance with the standard for storage and handling of liquefied gases (i.e. not indoors, but in a dry wellventilated area). The patio heater has been designed with several safety features which include a tip over switch. Any modification to the heater not described in the installation instructions may compromise the safety of this appliance. Special concern is as follows: 1. DO NOT shorten post length; 2. DO NOT bypass thermocouple safety; 3. DO NOT operate heater without a reflector; Clothing and other flammable materials should not be hung from the heater, or placed on or near the heater. The area above the post may be extremely hot. Direct contact with these metal surfaces should be avoided in order to prevent burns or clothing ignition. Installation Important safety rules: This appliance is for outdoor use only. 1. This appliance shall not be installed indoors, in buildings, garages or any other enclosed area 2. Do not place articles on or against this appliance 3. Do not use or store flammable materials near this appliance 4. Children and adults should be alerted to the hazards of high surface temperatures, burns and clothing ignition. 5. Children should be carefully supervised when they are in the area of the appliance 6. NEVER hang anything including clothes or other flammable items on the appliance 7. Do not operate this appliance unless it is fully assembled with the reflector in place. 8. DO NOT SPRAY AEROSOLES IN THE VICINITY OF THIS APPLIANCE WHILE IT IS IN OPERATION 9. Installation and repair should be done by a qualified service person. The appliance must be inspected before use and at least annually by a qualified service person. More frequent cleaning may be required if necessary. It is imperative that control compartment, burners and circulating air passengers of the heater be kept clean 10. In case of violent wind particular attention must be taken against tilting of the appliance